Termite Control Centurion for Beginners
DO NOT waste bait by adding it to timbers that do not contain live termites. The colony is killed only if workers take enough of the bait back to the nest. And they'll only take it whenever they can harvest it, undisturbed, from inside the damaged timber you've found. .
Watch the uneven surface of the window frame. Termites had eaten it out, in some regions leaving only the paint.
Get This Report about Termite Control Centurion
Make an opening into the termites using a pointed knife or fine screwdriver. The hole should be no bigger than about 5mm diameter to begin with. (It should be enlarged only when it's time to bring the cache of bait). You can pry into the surface of the wood in which it feels spongy, thin or hollow.
It's only as a last resort you should attempt to open a tunnel on a timber or foundation surface. .
Once you have broken through into where it's hollow, wait for a minute or so. If termites are there, the soldiers usually come to guard the opening while workers repair it. You may see their antennae and their heads blocking the gap. If no live pollutants appear, leave the gap open and come back later or check next day.
Termite Control Centurion Fundamentals Explained
This reveals how termites will come out from the infested timber into a foil covered mass of lure taped into the surface. Alternatively, if the surface is level, the feeder may be fixed within the pit and the termites will enter it to crop the lure.
If the wood has a flat surface, make the check hole away from corners so that you can line it up with the hole in the bottom of the feeder. If the access hole into the termites is on a round pole or another situation where you cannot fix the feeder to it, then you can earn a pouch of aluminium foil and duct tape to hold the bait in place.
If you're using the foil method, carefully pull back the border of the sticky tape to inspect and to replenish the bait. If you are using the feeder method, it is less disturbing if you can add more bait to the original feeder.
The termites you may see as dark brown nests high up in a tree are rarely pests of significance. Nevertheless, the main subterranean termites which do this 99% of the $damage we mentioned earlier, will often nest inside the central pipe or hollowed out heart of a mature tree. Mastos, the giant northern termite, dont always await the decay of the pipe.
Everything about Termite Control Centurion
(See the special box on Mastos).
If at colonising flight time a termite couple find their way into a hollow tree through maybe a dead/broken-off branch or in through a scar from fire at the basethey could not possibly have better conditions. Theres plenty to eat, moisture and protection. A 50 metre travel to your residence would not be hop over to here out of the question. .
In case you have a large eucalypt, peppercorn or even a mature fruit tree nearby, you should check it. Use an 15-20mm auger little long enough to drill into the centre of the trunk at about shoulder height. Drill at a slight downward angle and when you feel less resistance it'll be because you have reached the pipe.
The Ultimate Guide To Termite Control Can Also Be Done By
If not, you could slip in a long thin grass foliage click to read into the drill hole, leave it there for a minute and withdraw it slowly. Termites might be found holding on, attacking it. If still no live termites are found, return in half an hour or even next morning; if there is termite life inside, they'll be repairing or have mended the opening using their sand mixture. .
In this situation you dont need to see live termites; its only more satisfying to know you have actually killed a colony when you choose the next steps
Re-open the drill hole when it has been repairedUsing a funnel, plastic tubing and watering can/bucket, pour at least 20-30 litres of a chlorpyrifos or a bifenthrin solution down into the tree. These insecticidal concentrations can be purchased by a local hardware shop. They could be known by various brand names but the active ingredients are on the front panel of the label.